Cornelius ICE FROST Manual do Operador descarregar pdf (Página 11)

Ice Frost Operator’s Manual

ICE FROST GENERIC (POST-MIX)

• Switch the machine’s main switch to the ON position (1).

• Make sure the switch (L1) is in the OFF position (0) - Figure

6 - (switch L1 controls the flow of the products in the bowls).

• Turn mixing motors OFF immediately. Do not run units with

bowls empty.

• Using an 8 mm socket wrench (E1), loosen the nut that

holds the post-mix valve (D1).

• Twist nozzle counter-clockwise (F1), lift the post-mix valve

(D1) up slightly and turn it towards the outside. leaving

nozzle and coupling attached to the bowl.

FIGURE 6

Brix and Ratio Procedure

• Now pull the post-mix valve out further and tighten the 8mm

nut using the socket wrench (E1) - Figure 7.

FIGURE 7

• Remove the post-mix valve’s nozzle and apply the relevant

dose calibrator/separator (G1), then the relative measuring

cup (H1) and push the micro switch on the valve (l1) until

both the soda water and the syrup run into the measuring

cup separately (Figure 8).

• Check the BRIX: turn the water adjustment screw on the

solenoid valve clockwise to increase or counter-clockwise to

decrease the amount of water in the product.

• When the desired mix has been found, remove the parts G1

and H1, replace the spout on the post-mix solenoid valve,

then position it in its original seating, performing the previous

operations in reverse order.

• A refractometer may be used as an alternative to ratio

measurement.

FIGURE 8

• Repeat the same operations for the second bowl.

• Once the adjustments have been carried out for each bowl, place the switch (L1) in the ON position

(1).

• Both bowls will begin to fill up when the level sensor is activated.

• Turn mixing motors ON (located on the control board).

• Unit has built in delays for compressor and bowl fill switch.

• During initial filling it is normal for some foaming to take place. Bowl level management will adjust as it

freezes down and foam will dissipate.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 33 34

Sem comentários

Cornelius ICE FROST Manual do Operador Página 11