Cornelius 000 PLUS Manual descarregar pdf (Página 4)

CLASSIC 1000

REMOTE COOLER

5. The cooler is factory set on icebank mode. If

necessary, select water bath setting using the switch

behind the lower front panel.

6. Connect product coils to product lines. Check for

leaks.

7. Connect the recirculation lines to the ball valves.

Open both valves and top up the water level where

necessary.

8. Check the water flow. Remove the flow adjuster if

necessary.

9. Allow the cooler to build up its icebank (5 hours

minimum).

1. Installation must be carried out by a suitably trained

person and comply with national and local codes for

connection to the electrical supply.

2. Remove the packaging and fill the water bath with

cold mains water, to the level of the overflow. (The

cooler should not be moved once the water bath has

been filled with water.)

3. Assemble Ball Valves to pump. Ensure these are

closed. Check pump is plugged in.

4. Connect the 3 pin plug to the mains and switch on.

The mains on neon should illuminate.

Filler cap

Fill water bath here

Mains on indicator

Ice bank/water

bath switch

WARM AIR

EXHAUST

COOL AIR

INLET

15mm Ball valves

Open

Moulded mains

plug with 10A fuse

Overflow

Brass tails – to be used when

recirculation lines are

" I.D.

Flow adjuster –

remove for increased flow

Closed

➚

Plug for pump

24v socket

2.3 INSTALLATION

▼

1 2 3 4 5 6 7 8 9 ... 20 21

Comentários a estes Manuais

Sem comentários

Cornelius 000 PLUS Manual Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com não Cornelius 000 PLUS